Configure The Process Variables Shown On The Display - Emerson Micro Motion 5700 Configuration And Use Manual

Configure device options and preferences
7.1.2

Configure the process variables shown on the display

Display
ProLink III
Web browser
Overview
You can control the process variables shown on the display and the order in which they
appear. The display can scroll through up to 15 process variables in any order you choose.
This configuration applies to both auto-scroll and manual scrolling.
By default, one process variable is shown at a time. You can configure a custom display
screen that shows two process variables at a time.
Restriction
You cannot remove all display variables. At least one display variable must be configured.
Notes
•
•
Procedure
For each display variable, select the process variable to be shown in that position in the
rotation.
You can skip positions and you can repeat process variables.
Table 7-1:
Display variable
Display Variable 1
Display Variable 2
Display Variable 3
Display Variable 4
Display Variable 5
Display Variable 6
Display Variable 7
Display Variable 8
Display Variable 9
100
Menu > Configuration > Display Settings > Display Variables
Device Tools > Configuration > Transmitter Display > Display Variables
Configuration > Transmitter Display > Display Variables
If you have a display variable configured to show a volume process variable, and you change
Volume Flow Type to Gas Standard Volume, the display variable is automatically changed to the
equivalent GSV variable, and vice versa.
For all other display variables, if the process variable becomes unavailable due to changes in
configuration, the transmitter will not display that variable.
Default configuration for display variables
Process variable assignment
Mass flow rate
Mass total
Volume flow rate
Volume total
Density
Temperature
Drive gain
None
None
Micro Motion Model 5700 with Ethernet Transmitters