Enable Or Disable The Service Port - Emerson Micro Motion 5700 Configuration And Use Manual

3.
4.
5.
3.1.2

Enable or disable the service port

Display
ProLink III
Web browser
Overview
The service port is enabled by default, so you can use it for transferring files or connect to it
with ProLink III. If you want to completely prevent it from being used, you can disable it.
Note
Enabling or disabling the service port will not take effect until power has been cycled to the
transmitter.
CAUTION!
Do not use the service port if the transmitter is in a hazardous area. To use the service port, you
must open the transmitter wiring compartment. Opening the wiring compartment in a
hazardous area, while the transmitter is powered up, can cause an explosion.
Configuration and Use Manual
Figure 3-2: Removing the transmitter housing cover
Using a fine-pointed tool, move the switch to the desired position.
Replace the transmitter housing cover.
If necessary, power up the transmitter.
Menu > Configuration > Security > Service Port
Not available
Not available
Introduction to configuration and commissioning
19