Connect Prolink Iii To The Transmitter - Emerson Micro Motion 5700 Configuration And Use Manual

Using ProLink III with the transmitter
Note
If your PC has more than one wired network adapter, be sure to select the adapter that is connected
to the transmitter.
B.2.3

Connect ProLink III to the transmitter

CAUTION!
If the transmitter is in a hazardous area, do not open the wiring compartment while the
transmitter is powered up. Opening the wiring compartment while the transmitter is powered
up could cause an explosion. To connect to the transmitter in a hazardous environment, use a
connection method that does not require opening the wiring compartment.
Prerequisites
The transmitter and PC must be properly configured and physically connected to each
other by an Ethernet or USB cable, or they must both be connected to a local area Ethernet
network.
Procedure
1.
2.
3.
4.
258
Start ProLink III.
Choose Connect to Physical Device.
Select a Protocol and related settings:
• For Ethernet connection:
- Select Modbus TCP
- Type in the IP Address of the transmitter
- Leave the remaining settings at their default values
• For USB connection:
- Select Service Port
- Select the PC Port that is assigned to the PC USB Port
- Leave the remaining settings at their default values
Click Connect.
Micro Motion Model 5700 with Ethernet Transmitters