Load A Configuration File Using Prolink Iii - Emerson Micro Motion 5700 Configuration And Use Manual

Prerequisites
You must have a backup file or a replication file available for use.
If you are planning to use the USB drive, the service port must be enabled. It is enabled by
default. However, if you need to enable it, choose Menu > Configuration > Security and set
Service Port to On.
Procedure
•
•
3.2.4

Load a configuration file using ProLink III

You can load a configuration file to the transmitter's working memory. You can load a
backup file or a replication file. Two PC file formats are supported: the Model 5700 format
and the ProLink III format.
Backup files
Configuration and Use Manual
To load either a backup file or a replication file from the transmitter's SD card:
1. Choose Menu > Configuration > Save/Restore Config > Restore Config from
Memory.
2. Select Backup or Replicate.
3. Select the file that you want to load.
The file is loaded to working memory and becomes active immediately.
To load a either a backup file or a replication file from a USB drive:
1. Open the wiring compartment on the transmitter and insert the USB drive
containing the backup file or replication file into the service port.
CAUTION!
If the transmitter is in a hazardous area, do not open the wiring compartment while
the transmitter is powered up. Opening the wiring compartment while the
transmitter is powered up could cause an explosion. Save or load configuration files
using a method that does not require opening the wiring compartment.
2. Choose Menu > USB Options > USB Drive --> Transmitter > Upload Configuration
File.
3. Select Backup or Replicate.
4. Select the file that you want to load.
5. Choose Yes or No when prompted to apply the settings.
- Yes: The file is loaded to working memory and becomes active immediately.
- No: The file is loaded to the transmitter's SD card but not to working memory.
You can load it from the SD card to working memory at a later time.
Contain all parameters. They are used to restore the current device if
required. The .spare extension is used to identify backup files.
Introduction to configuration and commissioning
25