Software history (NAMUR recommendation NE53)
Table F-1:
Date
3/2017
272
Transmitter software change history
Software
version
Type
1.20
Software
improvements
(continued)
Change
•
Added ability to create PROFINET out-
put assembly (obsoletes ETO 27742)
•
Enhanced EtherNet/IP unicast so they
can communicate over different sub-
nets (obsoletes ETO 27792)
•
Added the ability to enable or disable
Ethernet Quality of Service and Mirror
Mode in ProLink III, the Web Pages, and
the EtherNet/IP DTM
•
Added the ability to change the trans-
mitter's time with the web host
•
Added ability to use the "sign out" but-
ton if the connection is lost while view-
ing a web browser
•
Added the ability to update the web
browser using either ProLink III or the
firmware installer
•
Enhanced both API Referral and Con-
centration Measurement applications
so that if either application is licensed,
the corresponding enable coil is auto-
matically set
•
Enhanced transmitters connected to a
slow managed switch so that it resolves
its DHCP address when both the switch
and the transmitters are turned on si-
multaneously
•
Enhanced the transmitter to correctly
calculate daylight savings time
•
Enhanced the local display so that
when the transmitter is configured for
gas standard volume, the local display
configures gas standard volume flow
cutoff and not volume flow cutoff.
•
Corrected the velocity calculation to
use actual density rather than the refer-
ence density when the transmitter is in
Gas Standard Volume mode
•
Corrected the local display cutoff digits
in the IP, subnet, and gateway ad-
dressed in the Menu > Configuration >
Ethernet settings menu.
•
Corrected the strings in the ASCII logs
so they display meaningful results
across all languages
Micro Motion Model 5700 with Ethernet Transmitters
Document
revision
20029769
Rev. AA