Quantum Data 802BT User Manual page 740

9500
9500
9501
9502
9503
9504
9505
9506
9507
9508
9520
9521
730 Appendix C Error Messages
I2C stream too big
There was a communications error within the generator hardware architecture because
the data stream size exceeded the size supported by the device.
Sequence data not found
An attempt was made to use the SEQR command to read a sequence from an empty
sequence storage location.
I2C data missing
There was a communications error within the generator hardware architecture because
the device data stream was missing.
I2C register missing
There was a communications error within the generator hardware architecture.
I2C data byte missing
There was a communications error within the generator hardware architecture because
the device data stream had missing data.
Serial digital video PLL not locked
There is an internal problem with the generator's serial digital video hardware's Phase
Lock Loop circuit.
TV output hardware not ready
The generator's serial digital video generating hardware is not yet ready to output video
Serial digital video hardware not ready
The generator's TV signal generating hardware reports it is not yet ready to output valid
video
I2C offset missing
There was a communications error within the generator hardware architecture
Invalid HDCP receiver KSV
The HDCP Key Selection Vector returned from the HDCP receiver in the Unit Under Test
(UUT) is not valid.
HDCP key combination not supported
The HDCP key combination between the Tx and the Rx is invalid. The Tx may have
production keys and the Rx public keys.
HDCP failed after a while
The HDCP authentication started but failed after a while.