Measuring Detailed Timing Parameters - Quantum Data 802BT User Manual

Video test generator
Hide thumbs Also See for 802BT:
Table of Contents

Advertisement

Measuring detailed timing parameters

116
Chapter 8 Analyzing Digital Sources and Cables
6. Press the G key to display the following format parameters on the LCD.
Horizontal pulse width (pixels)
Vertical pulse delay (pixels)
Active pixels per line
Horizontal period (pixels)
1040 800
666 600
Vertical period (lines)
Active lines
Horizontal pulse delay (pixels)
Vertical pulse width (pixels)
The analyzer can analyze detailed HDMI/DVI signal timing information. The timing
information is displayed on an HDMI/DVI display connected to the generator.
To view detailed timing information of an external HDMI/DVI source signal:
1. Connect the HDMI/DVI transmit device to the HDMI/DVI Rx connector on the generator.
2. Connect an HDMI/DVI display to the HDMI/DVI Tx connector on the generator.
3. If necessary, set the proper HDMI/DVI signal source parameters within the generator.
See
"Starting the Analyzer Setup
current analyzer configuration.
To edit HDMI/DVI signal source parameters, see
timing" on page 114.
4. If desired, monitor the video signal received on the HDMI Rx connector (see page 110).
5. Using the Format knob, select an appropriate format for the connected HDMI/DVI
display.
Note: To automatically configure the Format knob list based on the EDID structure of
a DDC-compliant display, hold down the R key, then press and release the ACS key.
56 120
37 6
Utility" on page 112 for steps on viewing the
"Setting up analyzer to measure

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 802BT and is the answer not in the manual?

This manual is also suitable for:

802r

Table of Contents