Quantum Data 802BT User Manual page 503

PUTR
Class
Description
Command syntax
Other required
commands
Video Test Generator User Guide
PUT Relative
Direct processor control
Writes the specified value value into the location pointed to by the address register (see
the ADDR command). The parameter value is interpreted according to the current setting
of BASE (see the BASE
the current setting of SIZE (see the
incremented by SIZE bits after the current location has been written to.
Note: This command is used only with custom applications and command files created by
Quantum Data. Indiscriminate use of this command can cause the generator to stop
operating and the loss of stored data in non-volatile RAM.
PUTR value
value
0 to (2^(SIZE))-1
PUTR expects parameters formatted according to the current radix set by the
command.
command). The number and format of the bits written depend on
SIZE command). The address register is automatically
BASE
493