Directory Errors - Quantum Data 802BT User Manual

4020
4030
4040
4045
4100
4576
4579

5000-5999 Directory errors

5002
5003
5006
802BT/802R Video Test Generator User Guide
No font present at given index
Attempt to access a font at a valid index but the specified index is empty because of a
previous delete.
Invalid font location
Can not install a font that has not first been transferred to memory.
Sequence is running
A sequence editing session can not be started while a sequence is running.
No sequence buffer
An attempt was made to change a parameter in a sequence step when there were no
sequence steps in the current sequence being edited.
Pattern index out of range
The selected index number for a drawing primitive's fill pattern is less than zero or greater
than the highest number used by the current firmware.
Can not convert to inches, not valid units
The format's current physical units of measure (inches or millimeters) is unknown and the
firmware is unable to convert a dimension to inches.
Can not convert to mm, not valid units
The format's current physical units of measure (inches or millimeters) is unknown and the
firmware is unable to convert a dimension to millimeters.
No directory memory
The DIRN or NAMI command failed because there is an insufficient amount of managed
memory for the buffer request.
Directory memory full
The DIRA or DIRS command failed because there is insufficient room in the directory
memory pool for the requested save.
No directory to save
An attempt was made to save the contents of a directory editing buffer when there was no
open directory editing session to save.
725