Quantum Data 802BT User Manual page 141

802BT/802R Video Test Generator User Guide
To view specific timing information of an external HDMI/DVI source signal:
1. Connect the HDMI/DVI transmit device to the HDMI/DVI Rx connector on the generator.
2. Using a terminal emulator, establish a terminal connection with the generator. Refer to
"Setting up a terminal connection with the
3. Enter the following commands to configure the generator to output a digital signal
(HDMI or DVI):
SROP 2 4
This removes analog friendly mode and configures the generator to output either a DVI
or HDMI signal depending on the interface hardware the generator is equipped with
(DVI or HDMI).
4. (optional) Enter the following command to set the status display mode:
SROP 8
5. Enter the following commands to initiate the measurement of timing parameters.
PNSF 1 // selects the source of timing information as "Measured"
TMAU // initiates measurement of timing from external source
HTOT? // queries for the horizontal total pixels
HRES? // queries for the horizontal active pixels
See page 548 for additional parameters you can query.
generator" on page 14.
131