Creating A Format Based On An Existing Format - Quantum Data 802BT User Manual

64 Chapter 4 Working with Formats
To create a new format:
1. Establish a terminal session with the generator. See
with the generator" on page 14.
2. Enter the following commands to initialize all parameters to default values and begin a
format editing session:
FMTN // initializes all parameters to default values
FMTB // begins a format editing session
3. Enter the format parameter commands in sequence to set the values for the new
format.
HRES 654 // sets the horizontal resolution to 654 pixels
.
. // other format parameters
.
HTOT 720 // sets the horizontal total to 720 pixels
Note: You do not need to enter a parameter value if it matches the FMTN default
setting.
4. End the editing session and save the new format using the following commands:
FMTE
FMTA new_fmt_name
5. Assign the format to the knob list using the following commands:
DIRL FMT
DIRB
NAMI 20 new_fmt_name
DIRE
DIRS

Creating a format based on an existing format

Use the following procedure to create a format based on an existing format using
interactive commands.
To create a custom format based on an existing format:
1. Determine the signal specifications of the display under test and select an existing
format in the generator's format library whose parameter values are similar.
2. Connect the display to the generator.
3. Using the Format knob, select the format you want to use as a template for the new
format.
4. Using the Image knob, select the Format image to view the parameters of the selected
format.
5. Establish a terminal session with the generator.
// ends a format editing session
// saves format as new specified name
// loads format directory into edit buffer
// begins a directory edit session
// assigns format to format knob list at 20
// ends a directory editing session
// saves contents of directory as current name
"Setting up a terminal connection