Head Assembly - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
X Axis Servo Motor

Head Assembly

1.
The head assembly has been designed for use with a wide range of
modeling materials. The board inside the head provides direct heater
and thermocouple control. The head extrudes modeling material and
support material with two identical liquefiers. The support liquefier
moves up and down via a drive motor.
2.
The liquefier tips are clamped directly between the heated block and
liquefier clamp block with two screws.
Note: You must replace each liquefier tip when you load a
different type of material.
Head-to-Mounting Plate
Retaining Screws
Figure 3-4: XY Gantry Assembly
Head Assembly
X Carriage Assembly
Figure 3-5: Head Assembly
Model Tip
Y Axis Servo Motor
Y Carriage
Assembly
(Figure 3-5)
Support Tip
3-5