Zero Air Scrubber Maintenance Kit (Option 43); Communication Options; Rs232 Modem Cable (Option 60); Multidrop (Option 62) - Teledyne 100E Instruction Manual

Optional Hardware and Software
moving at the specified flow rate. This calibration is performed at a tube temperature of
50° C.

5.4.4. Zero Air Scrubber Maintenance Kit (Option 43)

This kit includes the following items needed to refurbish the zero air scrubber, included
with the IZS valve options.
T-API Part No.
005960000
FL0000001
FL0000003
OR0000001

5.5. Communication Options

5.5.1. RS232 Modem Cable (Option 60)

This option consists of a cable to connect the analyzer's COM1 port to a computer, a code
activated switch or any other communications device that is equipped with a DB-9 male
connector. The cable is terminated with two DB-9 female connectors, one of which fits
the analyzer's COM1 port.
Some older computers or code activated switches with a DB-25 serial connector will need
a different cable or an appropriate adapter.
5.5.2. RS-232 Multidrop (Option 62)
The multidrop option is used with any of the RS-232 serial ports to enable
communications of several analyzers with the host computer over a chain of RS-232
cables. The option consists of a small box, which can be attached to the analzyer, with a
termination switch, a power connector and two serial ports, one incoming from the
analyzer (cable supplied) and one outgoing (requires additional cable) to the next
analyzer's multi-drop box. One Option 62 is required per analyzer. The first incoming port
on the first box connects to the host computer and the outgoing port on the last multi-
drop box needs to be terminated. Setup and user instructions are covered in the T-API's
multi-drop manual, part number 021790000.

5.5.3. Ethernet (Option 63)

The Ethernet option allows the analyzer to be connected to any 10BaseT local area
network. When installed, this option is electronically connected to the instrument's COM2
serial port making that port no longer available for RS-232/RS-485 communications
through the COM2 connector on the rear panel. The option consists of a T-API designed
Ethernet card (Figure 5-4), which is mechanically attached to the instrument's rear
panel. A 7-foot long, CAT-5 network cable terminated at both ends with standard RJ-45
connectors is included as well. Maximum communication speed is limited by the RS-232
port to 115.2 kBaud.
52
Activated charcoal
Sintered filter for span gas inlet fitting
Replacement particulate filter
1
O-Ring (qty:2)
Model 100E Instruction Manual
Description
1
045150102 Rev XB1