General Parameters - Cyclic Repeat Time (Hh:mm:ss); General Parameters - Value For Switching On Output 1; General Parameters - Value For Switching Off Output 1; General Parameters - Brightness-Value Threshold (Lux) - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.4.3 General parameters — Cyclic repeat time (hh:mm:ss)
Options:
- Here the time which lies between the sending of two telegrams is set.
11.4.4 General parameters — Value for switching on output 1
Options:
– On: When the presence detector detects movement, value 1 is sent via the bus.
– Off: When the presence detector detects movement, value 0 is sent via the bus.
11.4.5 General parameters — Value for switching off output 1
Options:
– Off: If movement is no longer detected and the switch-off delay has expired, value 0 is sent
via the bus.
– On: If movement is no longer detected and the switch-off delay has expired, value 1 is sent
via the bus.
11.4.6 General parameters — Brightness-value threshold (lux)
Options:
– This is used to set the desired brightness of the room. Below this threshold - hysteresis the
presence detector switched at movement. The presence detector switches off again when
the measured brightness - artificial light component = brightness-value threshold +
hysteresis.
Note
The value entered here is smaller than the control value set in the room via the
luxmeter. This depends on the calibration of the brightness sensor for brightness
detection settings. When the brightness adjustment is used there, the desired
brightness must be set here for the working area.
Example:
The brightness at the top of the desk is to be 500 lux. The presence detector, however,
measures the required brightness at the position it is mounted( e.g. on the ceiling it only
measures 20 lux). This means that there is a difference between the brightness of light at the
desk and the ceiling.
If the object is now used for "brightness adjustment" (daylight) or the objects "brightness
adjustment (output 1 / 2)", one can enter 500 lux here (after calibration of the brightness
sensor).
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
00:00:10 .. 00:00:30 .. 18:12:15
On
Off
On
Off
1 .. 20 .. 1000
Constant light switch application
│84