Setpoint Reached; Fahrenheit; Display Backlighting - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.19.34 Setpoint reached

Number
32
When the setpoint set on the device in comfort mode has been reached it is sent by means of
value (1) as information to the KNX bus via the 1-bit communication object. The function is
started by activating the comfort or presence mode. If the reaching of the setpoint temperature
is interfered with by the preselection of a different operating mode or by adjustment to a new
setpoint, value (0) is sent.

11.19.35 Fahrenheit

Number
33
The temperature indication on the display can be changed from Celsius (°C) to Fahrenheit (°F).
The conversion from Celsius to Fahrenheit always takes place in the display unit, since only
Celsius values are sent over the KNX bus. The value (0) results in a temperature indication in
Celsius, while the value (1) results in Fahrenheit.
Note
Item 2:
If the Fahrenheit object is active in the master/slave mode, the Fahrenheit
(slave) object must be connected to this object.
Item 3:
If the Fahrenheit object is active in the master/slave mode, the Fahrenheit
(master) object must be connected to this object.

11.19.36 Display backlighting

Number
34
The display backlighting is activated with value (1) and deactivated with value (0) via the 1-bit
communication object.
Note
This function is mainly used in rooms where backlighting during the night is
considered to be a disturbing factor, such as in hotel rooms and bedrooms.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Name
Setpoint reached
Name
1. Fahrenheit
2. Fahrenheit (master)
3. Fahrenheit (slave)
Name
Display backlighting
Communication objects — Object RTC
Object function
Output
Object function
Input / output
Input / output
Input / output
Object function
Input / output
Data type
Switching
Data type
Switching
Switching
Switching
Data type
Switching
│191