11.4.30 Sensor selection — Use of sensors 1 - 4
Options:
–
Yes: This sensor is active and detects movement.
–
No: This sensor is switched off and movement is no longer detected in this area.
Note
Does not apply for devices 6131/50-xxx and/or 6131/51-xxx. Here, the sensor
groups 1/2 or 3/4 can be activated.
Setting can be performed using the "Sensitivity of sensor 1/2 and/or 3/4"
parameter.
11.4.31 Sensitivity of sensor 1/2 and/or 3/4
Options:
–
Maximum: To be used when there are no interfering heat sources within the detection
range.
–
High: Standard - intended for indoor use.
–
Medium: To be used when there are small interfering heat sources within the detection
range.
–
Low: To be used when there are large interfering heat sources within the detection range.
–
Off: The sensor group is deactivated.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Yes
No
Maximum
High
Medium
Low
Off
Constant light switch application
│93