Table of Contents
Advertisement
11.7
"Brightness detection" application
11.7.1
General parameters — Sending of brightness every (hh:mm:ss)
Options:
–
Here it is specified how often the brightness is sent on the bus.
11.7.2
General parameters — Use of object for LED
Options:
–
No: There is no separate "LED" object.
–
Yes: There is a separate 1-bit "LED" object (input) for the option of switching on the LED via
an On telegram and to switch it off with an Off telegram.
Note
Only the LED has been switched. This does NOT place the device into
programming mode.
11.7.3
General parameters — Correction of internal brightness
Options:
–
No: It is not necessary to calibrate the internal brightness sensor.
–
With daylight adjustment: This adjustment is used mainly for the detector application.
–
With daylight and artificial light adjustment (1 output): This adjustment is used for the
constant light switch and constant light controller and only for one light row. It starts with the
daylight adjustment, and only if the control then does not function optimally can the the
artificial light adjustment be carried out.
–
With daylight and artificial light adjustment (2 outputs): This adjustment is used for the
constant light switch and constant light controller and for two light rows. It starts with the
daylight adjustment, and only if the control then does not function optimally can the the
artificial light adjustment be carried out.
Note
Information on how to perform the adaptation can be found in Chapter 7.2.6
"Instructions on the calibration of the internal light controller".
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
00:00:05 .. 00:00:30 .. 18:12:15
No
Yes
No
with daylight adjustment
with daylight and artificial light adjustment (1 output)
with daylight and artificial light adjustment (2 outputs)
"Brightness detection" application
│117
Advertisement
Table of Contents
