Table of Contents
Advertisement
11.3.7
General parameters — Cyclic repeat time (hh:mm:ss)
Options:
–
Here the time which lies between the sending of two telegrams (no change in value) is set.
11.3.8
General parameters — Value for switch-off
Options:
–
Off: If movement is no longer detected and the switch-off delay has expired, value 0 is sent
via the bus.
–
On: If movement is no longer detected and the switch-off delay has expired, value 1 is sent
via the bus.
11.3.9
General parameters — Cyclic sending of value for switch-off
Options:
–
No: The setpoint is sent only once via the bus.
–
Yes: The setpoint is sent cyclic via the bus.
–
Parameter "cyclic repeat time" is also displayed.
11.3.10 General parameters — Cyclic repeat time (hh:mm:ss)
Options:
-
Here the time which lies between the sending of two telegrams is set.
11.3.11 General parameters — Switch-off delay (hh:mm:ss)
Options:
–
The switch-off delay is the time period between the last movement detected and the sending
of the telegram "Value for switch-off". If movement is detected again within this period, the
switch-off delay timer is started again.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
00:00:10 ... 00:00:30 ... 18:12:15
On
Off
No
Yes
00:00:10 ... 00:00:30 ... 18:12:15
00:00:10 .. 00:05:00 .. 18:12:15
"Detector" application
│67
Advertisement
Table of Contents
