Table of Contents
Advertisement
11.3.45 Enable — Output sends at blockage
Options:
–
No telegram: No telegram is sent during blockage.
–
Off after expiry of switch-off delay: During blockage the switch-off delay is started anew and
the detector sends the value that is parameterised under the "value for switch-off" parameter
only after this time has expired.
–
Single value for switch-off: During enable the single value which has been parameterised
under the "value for switch-off" parameter is sent.
–
Single value for switch-on: During blocking, the single value which has been parameterised
under the "value for switch-on" parameter was sent.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
No telegram
OFF after expiration of the light-on time
Single value for switching off
Single value for switching on
"Detector" application
│80
Advertisement
Table of Contents
