Table of Contents
Advertisement
11.6.5
General parameters — Value for switch-off
Options:
–
Auto: When movement is no longer detected and the switch-off delay has expired,
value 0 (auto) is sent superimposed via the "HVAC" object on the bus to the "operating
mode" object, to reset the RTC into automatic mode.
–
Comfort: When movement is no longer detected and the switch-off delay has expired,
value 1 (comfort) is sent through the "HVAC" object to the bus.
–
Standby: When movement is no longer detected and the switch-off delay has expired,
value 2 (standby) is sent through the "HVAC" object to the bus.
–
ECO: When movement is no longer detected and the switch-off delay has expired,
value 3 (ECO) is sent through the "HVAC" object to the bus.
–
Frost/heat protection: When movement is no longer detected and the switch-off delay has
expired, value 3 (ECO) is sent through the "HVAC" object to the bus.
11.6.6
General parameters — Switch-on delay time (hh:mm:ss)
Options:
–
The switch-on delay time is a waiting period before the presence detector sends something
on the bus. In the standard setting the time is reset if movement is no longer detected during
this period. In fan mode (which can be set via the extended parameters) the time is not reset
and the "HVAC" object will always switch on.
11.6.7
General parameters — Switch-off delay (hh:mm:ss)
Options:
–
The switch-off delay is the time period between the last movement detected and the sending
of the telegram "Value for switch-off". If movement is detected again within this period, the
switch-off delay timer is started again.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Application "HVAC" (Heating, ventilation, air-conditioning)
Auto
Comfort
Standby
ECO
Frost/heat protection
00:00:10 .. 00:03:00 .. 18:12:15
00:00:10 .. 00:03:00 .. 18:12:15
│111
Advertisement
Table of Contents
