Table of Contents
Advertisement
11.6.20 Enable — After bus voltage recovery the device is
Options:
–
Enabled: The device is enabled and functions normally when the bus voltage is interrupted
or the device has been reprogrammed, as well as after a reset.
Blocked: The device is blocked and must be enabled for normal function when the bus
–
voltage is interrupted or the device has been reprogrammed, as well as after a reset.
11.6.21 Enable — Output sends at enable
Options:
–
No telegram: No telegram is sent during enable.
–
Current status: During enable the detector checks whether a movement exists. If yes, the
single value for switch-on is sent. Otherwise the single value for switch-off is sent.
–
Single value for switch-on: During enable the single value which has been parameterised
under the "value for switch-on" parameter is sent.
–
Single value for switch-off: During enable the single value which has been parameterised
under the "value for switch-off" parameter is sent.
11.6.22 Enable — Output sends at blockage
Options:
–
No telegram: No telegram is sent during blockage.
–
Off after expiry of switch-off delay: During blockage the switch-off delay is started anew and
the detector sends the value that is parameterised under the "value for switch-off" parameter
only after this time has expired.
–
Single value for switch-off: During blockage the single value which is parameterised under
the "value for switch-off" parameter is sent.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Application "HVAC" (Heating, ventilation, air-conditioning)
Enabled
Blocked
No telegram
Current status
Single value for switching on
Single value for switching off
No telegram
OFF after expiration of the light-on time
Single value for switching off
│116
Advertisement
Table of Contents
