Extended Parameters - Actual Brightness Is Sent Every (Hh:mm:ss); Extended Parameters - Use Of Object For Automatic / Manual Off; Extended Parameters - Exiting Manual Off Mode After (Hh:mm); Extended Parameters - Pause Time (Ss.fff) - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.4.24 Extended parameters — Actual brightness is sent every (hh:mm:ss)
Options:
- Here the time which lies between the sending of two telegrams is set.
11.4.25 Extended parameters — Use of object for automatic / manual off
Options:
– No: There is no separate "automatic/manual off" object.
– Yes: A 1-bit "automatic/manual off" communication object (input) is being enabled. With this
object one has the option of manually switching off the constant light switch with a 0
telegram for the time "Exiting manual off mode after (hh:mm)". The constant light switch will
function again automatically after this time period. The constant light switch can be set on
automatic again with a 1 telegram. This also important for regulating and automatic switch-
off independent of movement.
11.4.26 Extended parameters — Exiting manual off mode after (hh:mm)
Options:
– Here the time is set for when the constant light switch switches again to automatic mode
after a manual switch-off.
11.4.27 Extended parameters — Pause time (ss.fff)
Options:
– The set pause time is started after the detector has been switched off due to expiry of the
switch-off delay or when a switch-off telegram is received on objects "external push-button"
or "actuator status".
If movement is detected during this time, the detector is not switched on immediately. The
pause time is first extended by 7 seconds. If there is still movement after these 7 seconds,
the detector switches back on.
If no movement is detected during the pause time, the detector is ready for activation again
after the pause time.
This behaviour can, for example, be important when the lamp cools down drastically and is
located within the detection range of the detector. Without a blockage there would be an
unintentional switch-on. The purpose of pause time is to prevent an immediate re-activation.
Example: The person switches the light off manually when leaving the room. Without the
pause time the detected movement would cause a renewed switch-on during exiting.
Note
The "external push-button" object is activated under the "External push-button"
parameter.
The "actuator status" object is activated under the "status display" parameter.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
00:00:10 .. 00:05:00 .. 00:30:00
No
Yes
00:05 .. 01:00 .. 12:00
00.100 .. 01,250 .. 59,999
Constant light switch application
│91