11.4.10 General parameters — Sensitivity of the watchdog
Options:
–
High: Standard - intended for indoor use.
–
Medium: To be used when there are small interfering heat sources within the detection
range.
–
Low: To be used when there are large interfering heat sources within the detection range.
–
Maximum: To be used when there are no interfering heat sources within the detection
range.
Note
The transmission range can NOT be changed via the sensitivity.
The sensitivity refers to sensors 1, 2, 3, 4.
This parameter is not used for devices 6131/50-xxx and/or 6131/51-xxx. The
"Sensitivity of sensor 1/2 or 3/4" parameter under the sensor selection is used
for this purpose.
11.4.11 General parameters — Fade in extended parameters
Options:
–
No: One only sees the most important parameters for setting the presence detector.
–
Yes: All parameters are displayed, also those that are not required in most cases.
Examples:
–
Extended parameters
–
Sensor selection
–
Enable
–
No: Only the most important parameters for setting the presence detector are displayed.
–
Yes: All parameters are displayed, also those that are not required in most cases.
Examples:
–
Extended parameters
–
Sensor configuration
–
Enable
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
High
Medium
Low
Maximum
No
Yes
Constant light switch application
│86