General Parameters - Brightness-Value Threshold Internal (Lux); General Parameters - Sensitivity Of The Watchdog; General Parameters - Fade In Extended Parameters - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.3.12 General parameters — Brightness-value threshold internal (lux)
Options:
– The brightness-value threshold is used to specify the lux value at which the detector is to
start to respond. If the detector does not switch on and the measured brightness lies above
the set threshold, no telegram is sent during movement.
11.3.13 General parameters — Sensitivity of the watchdog
Options:
– High: Standard - intended for indoor use.
– Medium: To be used when there are small interfering heat sources within the detection
range.
– Low: To be used when there are large interfering heat sources within the detection range.
– Maximum: To be used when there are no interfering heat sources within the detection
range.
Note
The transmission range can NOT be changed via the sensitivity.
The sensitivity refers to sensors 1, 2, 3, 4.
This parameter is not used for devices 6131/50-xxx and/or 6131/51-xxx. The
"Sensitivity of sensor 1/2 or 3/4" parameter under the sensor selection is used
for this purpose.
11.3.14 General parameters — Fade in extended parameters
Options:
– No: Only the most important parameters for setting the detector are displayed.
– Yes: All parameters are displayed, also those that are not required in most cases.
Examples:
Extended parameter settings
■
Status display parameter
■
Brightness parameter
■
External button parameter
■
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
1 .. 400 .. 1000
High
Medium
Low
Maximum
No
Yes
"Detector" application
│68