Table of Contents
Advertisement
11.3.33 Brightness parameter — Use object for external brightness-value threshold
Options:
–
No: There is no separate "external brightness-value" threshold object.
–
Yes: A 2-byte "external brightness-value threshold" communication object (input) is being
enabled. This can be used to change the switching threshold at which the detector is
activated. The value is sent to this object in lux.
Note
The range of values lies between 0.5 – 1100 lux.
11.3.34 Brightness parameter — Brightness-value threshold external (lux)
Options:
–
The brightness-value threshold is used to specify the lux value at which the detector is to
start to respond. If the detector does not switch on and the measured brightness lies above
the set threshold, no telegram is sent during movement. The threshold applies only to the
external brightness.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
No
Yes
1 .. 500 .. 1000
"Detector" application
│76
Advertisement
Table of Contents
