General Parameters - Output Object Sends At; General Parameters - Value For Switch-On; General Parameters - Cyclic Sending Of Value For Switch-On - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.3.4 General parameters — Output object sends at
Options:
– Switch-on/switch-off: Sends a telegram at the start of movement and at the end of switch-off
delay.
– Switch-on: Only sends a telegram at the start of movement.
– Switch-off: Only sends a telegram at the end of switch-off delay.
Note
If switch-on or switch-off has been selected, the following parameters are not
displayed:
–
–
–
–
11.3.5 General parameters — Value for switch-on
Options:
– On: When the detector detects movement, value 1 is sent via the bus.
– Off: When the detector detects movement, value 0 is sent via the bus.
11.3.6 General parameters — Cyclic sending of value for switch-on
Options:
– No: The setpoint is sent only once via the bus.
– Yes: The setpoint is sent cyclic via the bus.
– Parameter "cyclic repeat time" is also displayed.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Switch-on / switch-off
Switch-on
Switch-off
Value for switch-on
Cyclic sending of value for switch-on
Value for switch-off
Cyclic sending of value for switch-off
On
Off
No
Yes
"Detector" application
│66