Table of Contents
Advertisement
Communication objects — Presence detector — Constant light controller
11.16.6 Px: slave
Number
6 | 24
The constant light controller can be switched on with a 1 from a different movement or presence
detector via the object.
11.16.7 Px: External brightness
Number
7 | 25
Via this object it is possible to link an external value from a different external brightness sensor
with the constant light controller. The internal brightness sensor is inactive for the constant light
controller.
11.16.8 Px: Enable presence
Number
8 | 26
The constant light controller can be blocked or enabled via the object. Enabling has priority over
all other objects.
11.16.9 Px: Switch-off delay
Number
10 | 28
If no movement is detected, the function enters the programmed switch-off and then switches
off. The switch-off delay can be reprogrammed at all times via this object from a different control
element without the aid of ETS. If this value is not to be overwritten during each download, the
parameter "Overwrite setting during download" is to be programmed accordingly.
11.16.10 Px: Setpoint brightness
Number
11 | 29
This communication object can be used to specify values from outside. This value is used as
the new setpoint. The current setpoint can be read via this communication object. If this value is
not to be overwritten during each download, the parameter "Overwrite setting during download"
is to be programmed accordingly.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Name
Px: slave
Name
Px: External brightness
Name
Px: Enable presence
Name
Px: Switch-off delay
Name
Px: Setpoint brightness
Object function
Input
Object function
Input
Object function
Input
Object function
Input
Object function
Input / output
Data type
1.001 switch
Data type
9.* 2-byte float value
Data type
1.001 switch
Data type
7.005 time (s)
Data type
9.* 2-byte float value
│173
Advertisement
Table of Contents
