Extended Parameters - Overwriting Settings During A Download; Sensor Selection - Use Of Sensors 1 - 4; Enable - Use Of Enable Object; Enable - Enable With - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.6.16 Extended parameters — Overwriting settings during a download
Options:
– Yes: When the application is reloaded into the detector, the values changed via the bus are
overwritten with the parameterised values of the ETS application.
– No: When the application is reloaded into the detector, the values changed via the bus are
not overwritten with the parameterised values of the ETS application.
Values:
– Switch-on delay
– Switch-off delay
11.6.17 Sensor selection — Use of sensors 1 - 4
Options:
– Yes: This sensor is active and detects movement.
– No: This sensor is switched off and movement is no longer detected in this area.
11.6.18 Enable — Use of enable object
Options:
– No: There is no object with which the HVAC control can be blocked or enabled.
– Yes: A 1-bit "enable heating, ventilation and air-conditioning communication" object (input) is
being enabled. This object allows the HVAC control to be enabled or blocked. No telegrams
are sent by the detector during blockage.
11.6.19 Enable — Enable with
Options:
– On telegram: With the receipt of value 1 on the "enable movement" (input) object, the
detector is enabled and blocked with value 0.
– Off telegram: With the receipt of value 0 on the "enable movement" (input) object, the
detector is enabled and blocked with value 1.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Application "HVAC" (Heating, ventilation, air-conditioning)
Yes
No
Yes
No
No
Yes
ON telegram
OFF telegram
│115