Sensor Selection - Use Of Sensors 1 - 4; Enable - Presence Detector Enable Object; Enable - Enable With; Enable - After Bus Voltage Recovery, Presence Detector Is - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.5.42 Sensor selection — Use of sensors 1 - 4
Options:
– Yes: This sensor is active and detects movement.
– No: This sensor is switched off and movement is no longer detected in this area.
11.5.43 Enable — Presence detector enable object
Options:
– No: There is no object with which the constant light controller can be blocked or enabled.
– Yes: A 1-bit "enable presence" communication object (input) is being enabled. This object
allows the constant light controller to be enabled or blocked. No telegrams are sent by the
detector during blockage.
11.5.44 Enable — Enable with
Options:
– On telegram: With the receipt of value 1 on the "enable movement" (input) object, the
detector is enabled and blocked with value 0.
– Off telegram: With the receipt of value 0 on the "enable movement" (input) object, the
detector is enabled and blocked with value 1.
11.5.45 Enable — After bus voltage recovery, presence detector is
Options:
– Enabled: The device is enabled and functions normally when the bus voltage is interrupted
or the device has been reprogrammed, as well as after a reset.
Blocked: The device is blocked and must be enabled for normal function when the bus
–
voltage is interrupted or the device has been reprogrammed, as well as after a reset.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
Yes
No
No
Yes
ON telegram
OFF telegram
Enabled
Blocked
"Constant light controller" application
│107