Table of Contents
Advertisement
6.4
Installation
The device is designed for mounting on ceilings. The overall function of the device also
depends on the mounting height (see chapter 6.2).
Note
The device does not fit in the BS and VDE flush-mounted box.
Recommendation:
–
–
–
6.4.1
"Flush-mounted" ceiling mounting (e.g. suspended ceilings)
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
HaloX-O flush-mounted box from Kaiser (article no. 1290-40) with
corresponding cover (article no. 1290-47 or article no. 1290-85 for exposed
concrete)
IBTronic H120-68 from Spelsberg (article no. 97600501)
Mounting to VDE flush-mounted box using the intermediate ring (6131/38-
xxx) (with the exception of 6131/20-xxx + 6131/21-xxx)
Ø 68 mm
Preparation:
First a recess with a diameter of approx. 68 mm must
■
drilled into the ceiling.
A sufficient length of KNX bus line must project from
■
the hole.
Connection of the integrated KNX bus coupler (rear
of the device):
Connect the KNX bus line with the enclosed 2-pole
■
bus connection terminal (see connection diagram in
Chapter 5.3). The connection is reverse polarity
protected!
Slide the bus connection terminal into the push-on
■
fixture provided. Screw on the enclosed strain relief
as an option.
Mounting
│47
Advertisement
Table of Contents
