Commissioning; Hardware; Software; Preparatory Steps - Busch-Jaeger mini KNX 6131/20 series Technical Manual

7

Commissioning

Note
The devices are a product of the KNX system and meet KNX guidelines.
Detailed expert knowledge by means of KNX training sessions for a better
understanding is assumed.
7.1

Hardware

Note
Please observe the mounting instructions in Chapter 6.
The detection range can additionally be adapted through individual sectors with switch-off
function (through parameter settings).
Note
The device contains highly sensitive sensors and lens systems.
■
7.2

Software

To start the device a physical address must be assigned first. The assignment of a physical
address and setting of parameters is carried out with the ETS commissioning software (from
ETS version 3.0 f/Power Tool, ETS 4/Power Tool with native application; ETS 5/ only native
application).
7.2.1

Preparatory steps

1. Connect a PC via the KNX interface, e.g. the commissioning interface / adapter 6149/21, to
the KNX bus line. The ETS commissioning software (from version ETS 3.0 f/Power Tool;
ETS 4/Power Tool with native application; ETS 5/ only native application) must have been
installed.
2. Switch on the bus voltage.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Do not cover or mask lens segments since this will interfere with the function
of the device.
Commissioning
│55