Extended Parameters - Sending Of Actual Brightness Every (Hh:mm:ss); Extended Parameters - Use Of Brightness Calibration Object; Extended Parameters - Control Speed Adjustment Through Blind Inputs; Extended Parameters - Total Movement Time Of Blind / Roller Blind (Hh:mm:ss) - Busch-Jaeger mini KNX 6131/20 series Technical Manual

11.5.29 Extended parameters — Sending of actual brightness every (hh:mm:ss)
Options:
- Here the time which lies between the sending of two telegrams is set.
11.5.30 Extended parameters — Use of brightness calibration object
Options:
– No: There is no separate "brightness calibration" object.
– Yes: A 1-byte "brightness calibration" communication object (input/output) is being enabled.
If a 1 telegram is sent to this object, the calibration of artificial light starts. This means that
the constant light controller sends the maximum value to output 1 and 2 and then the light
slightly measured each time to record the the measured values for a reference table.
11.5.31 Extended parameters — Control speed adjustment through blind inputs
Options:
– No: There are no separate settings for adjusting the control speed when a venetian blind
control unit is available.
– Yes: There are separate settings: control parameters for the movement of blinds. If a blind
now moves up or down, the control speed is adjusted by the constant light controller during
the travel time.
11.5.32 Extended parameters — Total movement time of blind / roller blind (hh:mm:ss)
Options:
– Here the time is specified how long it takes until the shading has been carried out
completely (blind/roller blind closed).
11.5.33 Extended parameters — Dimming step size brighter (1 to 15)
Options:
– Here the step size for increasing the dimming value during blind movement is specified.
Note
If the dimming step size is set too high, the dimming steps will be clearly visible
in the lighting.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
00:00:05 .. 00:05:00 .. 00:30:00
No
Yes
No
Yes
00:00:01 .. 00:03:00 .. 01:40:00
1 .. 15
"Constant light controller" application
│104