Table of Contents
Advertisement
6.4.3
"Surface-mounted" ceiling installation on VDE flush-mounted box with intermediate
ring (optional intermediate ring, article no. 6131/38-xxx) (with exception of 6131/20-xxx
+ 6131/21-xxx)
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Slide the KNX bus line into the intermediate ring
■
through one of the specified openings. A sufficient
length of KNX bus line must project from the hole.
Fasten the intermediate ring with screws.
■
Remove the two clamps on the device with the aid of
■
a screwdriver and dispose of them.
Connection of the integrated KNX bus coupler (rear
of the device):
Connect the KNX bus line with the enclosed 2-pole
■
bus connection terminal (see connection diagram in
Chapter 5.3). The connection is reverse polarity
protected!
Slide the bus connection terminal into the push-on
■
fixture provided.
Mounting
│52
Advertisement
Table of Contents
