11.4
Constant light switch application
11.4.1
General parameters — Output is of type
Options:
–
1 Bit: Intended for switch actuators.
–
1 Byte 0 - 100%: For activating dimmers.
–
1 Byte 0 - 255: For actuators, which are activated with a value of between 0 and 255.
–
Light scene number 1 - 64: For activating light scenes.
–
RTC operating mode switchover (1 Byte): To directly switch room temperature controllers
into a specific operating mode.
–
Auto
–
Comfort
–
Standby
–
ECO
–
Frost/heat protection
–
2-byte float: To send a specific temperature for example.
Note
If the type of output is changed, also the options for setting the parameters
change.
–
–
and when they are activated also for:
–
–
In this manual only values for the 1-bit setting are described.
11.4.2
General parameters — Cyclic sending of value for switch-on
Options:
–
No: The setpoint is sent only once via the bus.
–
Yes: The setpoint is sent cyclic via the bus.
–
Parameter "cyclic repeat time" is also displayed.
KNX Technical Manual 2CKA001473B8667 │ 06.02.2017
Description of application and parameters
1 bit
1 byte 0 - 100%
1 byte 0 - 255
Light scene number (1-64)
RTC operating mode switchover (1 byte)
2-byte float
Value for switch-on at output 1
Value for switch-off at output 1
Value for switch-on at output 2
Value for switch-off at output 2
No
Yes
Constant light switch application
│83