Changing The Display; Display Setting - NTT docomo FOMA SO706i Instruction Manual

Setting the Original manner
You can set your preferred Manner mode setting.
The following are the default settings of the
"Original" manner mode:
• Record msg.: OFF
• Vibrator: ON
• Phone vol.: Silent
• Mail vol.: Silent
• Alarm vol.: Silent
• i-αppli vol.: Silent
• VM tone: ON
• Keypad sound: OFF
• Mic sensitiv.: Up
• LVA tone: OFF
1 Manner mode set screen (p.86)
"Original" Select any item:
Record msg.......Sets the Record message. →p.64
Vibrator......Sets the vibrator.→ p.84
Phone vol.......Sets the ring tone volume for voice/
videophone calls and 64K data communication.
→ p.61
Mail vol.......Sets the ring tone volume for mail,
packet communication and MessageR/F.→p.61
Alarm vol.......Sets the volume of the alarm.
→ p.284
i-αppli vol.......Sets the volume of the i-αppli.
→ p.189
However, "Step" cannot be set.
VM tone......Sets confirmation tones for "Record
msg.", "Voice memo", etc.
Keypad sound......Sets the keypad sound. →p.85
Mic sensitiv.......Selects from "Normal/Up" for the
microphone sensitivity during calls.
LVA tone......Sets the low-voltage alarm.
"When the battery runs out"→p.44
Set the respective items o (Finish)
2
N
The record message function set in "Original" starts
up after the ringing time set in "Record message"
(p.64) (when set to "OFF", the recording starts after 13
seconds).
If the microphone sensitivity during calls is set to "Up",
the volume of the voice heard by the other party raises
even if you speak quietly. The microphone sensitivity
is set to "Normal" when shooting movies in "Camera"
mode.
88

Changing the Display

You can also set the still images you shot or
downloaded images as the standby screen, dialing/
calling screen, etc.
i "SETTINGS" "Display"
1

"Display setting"

The "Display setting" screen
appears.
2 Select any item:
Stand-by display......Changes the standby screen
image.→ p.89
Wake-up display......Specifies a message or image
displayed when the FOMA terminal is turned on.
OFF......Does not display an image, etc.
Message......Enters a message. You can enter
up to 50 double-byte or 100 single-byte
characters.
My picture......Selects an image to be
displayed from My picture.
Dialing/Calling/V.phone Dialing/V.phone Calling/
Mail sending/Mail receiving......Sets the image
displayed when making/receiving voice/videophone
calls or sending/receiving mails (i-mode mails and
SMS).
■Dialing/V.phone Dialing/Mail sending setting
Select from My picture.
■Calling/V.phone Calling/Mail receiving setting
"Changing the Ring Tone (Step 2)"→p.82
Check new messages・Mail rec'd
the image displayed for "Check new messages"
(i-mode mails and messages), "Check new SMS" or
mail received result screen from My picture.
N
Some i-motion cannot be specified.
<Display setting>
Display setting
result......Selects