Adding Frames - NTT docomo FOMA SO706i Instruction Manual

Trim away......Trim a constant size.
Select the image size for trimming
position to trim with b d (Set)
Brightness......Selects the brightness in 5 levels
from "-2 to ± 0 to +2" using v.
Rotate......Selects the angle to rotate the image
from "90° to right/90° to left/180°".
Change size......Selects the image size for
changing. The image is enlarged or reduced to fit in
the selected size keeping the aspect ratio.
Correct backlight......Makes the dark part clear,
which is caused by the backlight.
Refresh skin tone......Corrects the skin parts.
Compose message
*1
......Saves the edited image.
Save
*1: This function is available after editing an image.
*2: Not available when 2in1 is in B mode.
Check the edited image d (Set)
2
d (Save) "YES" or "NO"
3
Selecting "YES" overwrites the original image.
Selecting "NO" saves a new image to the folder
where the original is stored.
N
Editing repeatedly may impair the image quality or
increase the file size.
● Adding frames
You can use the downloaded frames in addition to
the pre-installed ones.
My picture screen (p.226) u (FUNC)
1
"Edit image" "Frame" Select a
frame
The image is displayed in the selected frame.
Use v to change to another frame.
■ To rotate the frame 180°
o (Rotate)
■ To cancel the selected frame
u
(FUNC) "Cancel"
N
If the size of the image that has been trimmed or
resized is the same as that of the frame, the image
can be framed.
232
Adjust the
*1*2
→p.230
● Pasting image stamps
You can use downloaded image stamps in addition
to pre-installed ones.
You can rotate, enlarge or reduce image stamps.
My picture screen (p.226) u (FUNC)
1
"Edit image" "Image stamp"
Select an image stamp
■ To edit an image stamp
u
(FUNC) Select any item:
90° to right......Rotates 90° clockwise.
90° to left......Rotates 90° counterclockwise.
180°......Rotates 180°.
Scale up......Doubles the size.
Scale down......Reduces the size to half.
Adjust the image stamp position with
2
b d (Put)
■ To paste another image stamp
o
(Add) Repeat steps 1 to 2
N
You can only use downloaded stamps of 240 dots
wide × 240 dots high or smaller. The stamps larger
than the above size are handled as GIF images.
● Pasting character stamps
You can enter up to 15 double-byte or 30 single-
byte characters as a stamp. The number of
characters that can be entered differs depending
on the image size and character size.
You can change the character stamp color, font and
size.
My picture screen (p.226) u (FUNC)
1
"Edit image" "Character stamp"
Enter characters
■ To edit a character stamp
u
(FUNC) Select any item:
Character input......Enters the character.
Character color......Sets the color.
To use another color palette, press o (Change).
Font type......Selects "Gothic" or "Ming-cho".
Font size......Selects the size from "Enlargement
size/Standard size/Reduction size".
Adjust the character stamp position
2
with b d (Put)
N
The font thickness is specified in the "Font" setting.