Using Ssl Certificates - NTT docomo FOMA SO706i Instruction Manual

Setting the connection timeout
This option sets time-out duration for which the
FOMA terminal automatically stops trying to connect
when a site is busy and there is no response.
i "SETTINGS" "i-mode common
1
set" "Set connection timeout"
Select any item:
60 seconds......Automatically stops connecting if
there is no response for 60 seconds.
90 seconds......Automatically stops connecting if
there is no response for 90 seconds.
Unlimited......Does not automatically stop
connecting.
Setting a host different from i-mode
host (ISP connection)
* There is normally no need to change this
setting.
You need to select a different host when you want to
use a service other than i-mode. If you change the
host to a host other than i-mode, you can not use
i-mode and i-mode mail.
You can store up to 10 hosts other than "i-mode".
i "SETTINGS" "i-mode common
1
set" "Host selection" Highlight
"<Not recorded>" o (Edit) Enter
your security code Select any item:
Host name......Sets the host name. You can enter
up to 9 double-byte or 18 single-byte characters.
Host number......Sets the host number. You can
enter up to 99 single-byte characters.
Host address......Sets the host address. You can
enter up to 30 single-byte characters.
Host address2......Sets the host address2. You can
enter up to 30 single-byte characters.
Set the respective items o (Finish)
2
N
Note that costs of packet communication while you are
connected to a host other than i-mode are not covered
by the Pake-Houdai or Pake-Houdai full deal.
When you change the host, the ticker of i-Channel is
turned off. The ticker is turned on again automatically
when the information is updated automatically or
when p is pressed to receive the latest information.
<Set connection timeout>
<Host selection>
N
After changing the host, the i-Channel information
may not be updated automatically. To receive the
latest information, press p to display the channel list
screen.
Specifying whether to use terminal
data in Flash movies
Use this function to specify whether terminal data is
used when a Flash movie is running.
The terminal data may be used depending on the
particular Flash movie. Select "Accept" in "Use
phone information" of "i-mode settings" so that
images use the terminal data. The default setting is
"Accept". Such movies may use the following types
of terminal data:
• Battery level
• Signal strength
• Date and time
i-mode setting screen (p.148) "Use
1
phone information" "Accept" or
"Reject"

Using SSL Certificates

You can check the details of an SSL certificate or to
set to valid/invalid.
i "SETTINGS" "i-mode common
1
set" "Certificate"
2 Select a certificate Check the details
■ To validate or invalidate SSL certificates
Highlight a certificate
Invalid"
N
When set to "Valid", "
"Invalid", " " appears.
If you select "Invalid", you cannot view SSL pages with
that SSL certificate.
<Use phone information>
• Ring volume setting
• Select language
• Model data
u
(FUNC) "Valid/
" appears. When set to
149