Reconnection - NTT docomo FOMA SO706i Instruction Manual

i "SETTINGS" "Dialing" "Prefix
1
setting"
The "Prefix setting" screen
appears.
2 Highlight the item to
store or change
o (Edit)
Enter the name to be
3
stored
You can enter up to 8 double-byte or 16 single-
byte characters.
Enter the numbers (prefix)
4
You can enter up to 10 digits.
Prefix setting screen (p.58)/IDD
Prefix setting screen (p.52)
Edit......Edits the prefix number or IDD prefix code.
Delete this・Delete all......Deletes one or all prefix
numbers/IDD prefix codes.
Making a call with the Prefix numbers
You can add the prefix numbers from the "Enter
phone number" screen and the detail screens of
"Phonebook/Received calls/Dialed calls/Redial"
screens.
<Example: To make a voice call by adding prefix
numbers from the enter phone number screen>
1 Enter the phone number of the other party
u (FUNC)
"Prefix numbers" Select
2
the stored name r
Setting Sub-addresses When
Making Calls
You can set whether to specify "*" in the phone
number as a separator so that the numbers following
"*" are recognized as a sub-address (ON/OFF).
Sub-addresses are used in ISDN to identify calls
made from specific communications devices and to
select content in "V-live".
i "SETTINGS" "Dialing" "Sub-
1
address setting" "ON" or "OFF"
58
Prefix setting
Function menu p.58
<Prefix numbers>
<Sub-address setting>
N
In the following cases, "*" does not function as a sub-
address separator. The entered number including "*"
is recognized as an ordinary phone number:
• When the "*" is entered at the beginning of a
phone number
• When "*" immediately follows "186"/"184" at the
beginning of a phone number
• When "*" immediately follows a number entered
using "Prefix numbers"
• When the phone number contains "*590#/*591#/
*592#"
Setting the Alarm Used for

Reconnection

When the signal quality deteriorates during a voice/
videophone call and the call drops out, the FOMA
terminal will automatically reconnect the call if the
signal quality quickly improves. Set the type of alarm
when a call is reconnected for this function.
The interval for reconnection varies depending on
communication conditions or the signal quality. It
takes about 10 seconds.
i "SETTINGS" "Talk" "Reconnect
1
signal" Select an alarm tone
Select from "No tone/High tone/Low tone".
N
Call charges apply in the interval (up to about 10
seconds) for reconnection.
Blocking Out Ambient Noise
This function suppresses ambient noise and makes it
easier for the other party in a voice or videophone call
to hear you.
i "SETTINGS" "Talk" "Noise
1
reduction" "ON" or "OFF"
<Reconnect signal>
<Noise reduction>