NTT docomo FOMA SO706i Instruction Manual page 440

Easy settings: "Settings for Packet communication using mopera U or mopera"
d This section explains how to make settings for a packet communication of 3.6Mbps maximum. The
DOCOMO Internet connection service "mopera U" or "mopera" will be used as a provider (When you use
"mopera", the communication speed is 384kbps at maximum for both sending and receiving.).
Packet communication: Enables high-speed packet communication of up to 3.6Mbps for receiving
and up to 384kbps for sending (The communication speed is 384kbps at maximum for both sending
and receiving outside FOMA HIGH-SPEED area.). Since you will be charged according to the amount
of data transferred, you can enjoy data communication without worrying about time.
d Note that the communication charge can become expensive if "packet communication" is used to communicate
large volumes of data such as to view sites and websites containing images or to download files.
Click "かんたん設定" (Easy settings)
1
Select " パケット通信（HIGH-SPEED 対応端末）" (Packet communication
2
(HIGH-SPEED phone)) and click "次へ" (Next)
For Windows Vista
Select " パケット通信 " (Packet communication) and click "次へ " (Next)
Select "『mopera U』への接続" ('mopera U' access) or "『mopera』への接
3
続" ('mopera' access) and click "次へ" (Next)
When you select "『mopera U』への接続 " ('mopera U' access), subscription confirmation message
appears. Click " はい " (Yes) when you have already subscribed to mopera U.
See p.20 if you use a provider other than mopera U or mopera.
Click "OK"
4
The access point (APN) settings will be obtained from the FOMA terminal which is connected to the PC.
Wait for a while.
Enter the connection name, select the
5
connection method and click " 次へ"
(Next)
You can specify the name of the connection.
Enter a name easy to recognize in the " 接続名 "
(Connection name) column.
You cannot use the following reserved
characters: ¥/: ＊ ?!<> │"(half-pitch only).
Select the " 発信者番号通知 " (Caller ID setting)
and "接続方式 " (Connection method).
As for " 発信者番号通知 " (Caller ID setting),
select " 設定しない（推奨）" (OFF
(Recommended)) for overseas use.
As for "接続方式" (Connection method), mopera U
supports both "PPP接続 " (PPP connection) and "IP接
続" (IP connection). Select "IP接続" (IP connection) for
overseas use. mopera supports "PPP接続 " (PPP
connection) only, therefore is not available overseas.
Specify a user ID and password,
6
select the accessible user and click
"次へ" (Next)
You can leave user ID and password blank for
the mopera U or mopera connection.
When " すべてのユーザー " (All users) is
selected in the "使用可能ユーザーの選択 "
(Selecting accessible user) column, the
connection setting is applied to all the users
registered in Windows.
For Windows Vista
Specify the user ID and password and click
" 次へ " (Next)
Proceed to Step 8.
19