NTT docomo FOMA SO706i Instruction Manual page 455

If a COM port of "FOMA SO706i" cannot be
selected
Click " キャンセル " (Cancel) to close the "接
続の設定 " (Connection Settings) screen and
then follow the steps below:
(1) Select " ファイル " (File) menu → "プロパ
ティ " (Properties)
(2) Select "FOMA SO706i" in the " 接続方法 "
(Connection method) column of the " 接続
の設定 " (Connection Settings) tab on the
"sample のプロパティ " (sample
Properties) screen
(3) Uncheck " 国 / 地域番号と市外局番を使
う " (Use the Country/Region Code and
Area Code)
(4) Click "OK"
Enter the access point (APN) and
7
press
Enter in the format of AT+CGDCONT=<cid>,
"PDP_type", "APN"
<cid>： Enter any number from 2 or between 4
and 10.
Please be cautious because if cid has been
already set, the setting will be overwritten.
"PDP_type"： Enter "PPP" or "IP".
"APN"： Put " " around the access point (APN)
to enter.
If "OK" is displayed, the settings for the access
point (APN) are completed.
Example: To enter APN named XXX.abc in cid
Number2
Enter AT+CGDCONT=2,"PPP","XXX.abc"
Confirm that "OK" appears and click " ハイパーターミナルの終了" (Close
8
Hyper terminal) in the "ファイル" (File) menu
""sample" と名前付けされた接続を保存しますか？ " (Are you going to save the connection "sample"?)
appears, but it is not necessary to save.
NOTE
d The AT commands entered in "Hyper terminal" may not be displayed after Step 7 on p.34. In this case, if you enter
ATE1 , AT commands you enter from then on are displayed.
d To reset the access point (APN) settings using the AT command
・ If reset, the access point (APN) setting with cid=1 will return to "mopera.ne.jp" (Default value) and cid=3 to "mopera.net" (Default
value), and cid=2, 4 through 10 will be unregistered.
<How to enter>
AT+CGDCONT=
AT+CGDCONT=〈cid〉
d To confirm the access point (APN) settings using the AT command
・ Display the current settings.
<How to enter>
AT+CGDCONT?
(to reset all cid)
(to reset a certain cid only)
.
34