Configuring Diagnostics Quick Mode; Setting User Access Limitations Using Acli - Avaya 5900 Series Quick Start Configuration

Configuring diagnostics quick mode

The diagnostics quick mode flag enables you to choose the diagnostic test behavior during boot.
You can enable quick mode boot tests or all the diagnostic tests. The impact to boot time is 15 to 20
seconds when all diagnostic tests run during startup.
The diagnostic quick mode is disabled by default.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable the diagnostics quick mode flag, enter the following command at the command
prompt:
diagnostics-quick-mode enable
3. To disable the diagnostics quick mode flag, enter either of the following commands at the
command prompt:
no diagnostics-quick-mode enable
OR
default diagnostics-quick-mode
4. To display the configuration, enter the following command at the command prompt:
show diagnostics-quick-mode
Example
Enable diagnostics quick mode:
Switch>enable
Switch#configure terminal
Switch(config)#diagnostics-quick-mode enable
Switch(config)#show diagnostics-quick-mode
2013-10-02 08:53:27 GMT+00:00
Diagnostics quick mode:

Setting user access limitations using ACLI

The administrator can use ACLI to limit user access by creating and maintaining passwords for web,
telnet, and console access. This is a two-step process that requires that you first create the
password and then enable it.
Ensure that you enter Global Configuration mode in ACLI before you start these tasks.
October 2015
Enabled
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Configuring diagnostics quick mode
27