Configuring Ospf Nbma Neighbors - Avaya 8800 Configuration Manual

Variable definitions
Use the data in the following table to help you use the commands:
• config ip ospf host-route <ipaddr>
• config ip vrf <vrfName> ospf host-route <ipaddr>
create [metric <value>]
delete
info
Job aid
Table 26: show ip host-route command parameters
HOSTIPADDR
TOS
METRIC

Configuring OSPF NBMA neighbors

Configure NBMA neighbors so that the interface can participate in Designated Router election.
All OSPF neighbors that you manually configure are NBMA neighbors.
You configure OSPF on a VRF the same way you configure the GlobalRouter, except that you
must replace config ip with config ip vrf <vrfName> in the following procedure. The
VRF must have an RP Trigger of OSPF. Not all parameters are configurable on non0 VRFs.
Configuration — OSPF and RIP
Variable
Creates an OSPF host route for the IP address and
configures the metric (cost) for the host route.
<value> is from 1 to 65535.
Deletes an OSPF host route for the IP address.
Displays the current OSFP host route configuration on the
switch.
Field
Indicates the IP address of the host.
Indicates the Type of Service of the route. Administrators
use TOS routing to install multiple routes to a destination
for each type of service (for example, low delay or high
throughput.) An OSPF router uses the destination address
and the TOS to choose the best route.
Indicates the advertised metric.
Configuring OSPF NBMA neighbors
Value
Description
June 2011 179