Options - Extron electronics XMP 240 C AT User Manual

Dante Device Network Settings
To configure Dante network settings:
1.
2.
3.
To reboot the Dante interface:
1.
To refresh the device name and network configuration displayed:
1.
Redundant Mode
In redundant mode, the 2-port AT switch becomes separate Primary and Secondary ports
(see
To enable redundant mode:
1.
2.

Options

The
DSP Configurator color schemes, default processor and gain block behavior, as well as a
number of other settings. For a comprehensive overview of the
DSP Configurator Help file.
Figure 119.
Select the or
DHCP Static IP
using DHCP, the XMP 240 C AT Dante interface will be assigned an IP address by the
DHCP server and Dante network configuration is complete. If
proceed to step 2.
Enter a valid network configuration into the respective fields.
Click .
Apply
Click . Only the Dante interface will reboot, not the entire XMP 240 C AT.
Reboot Dante
Click to have DSP Configurator refresh information from the XMP 240 Dante
Refresh
interface.
Redundant Configuration
Click the
Enable Redundant Mode
By default, the radio button is selected to have the DHCP server assign a
DHCP
redundant network configuration. If necessary, select the
the redundant network configuration in the text boxes that appear below.
NOTE: A valid redundant static network configuration must be entered.
dialog box allows the user to edit and reset default options for
Options
Options Dialog Box
radio buttons (see figure 118
on page 96).
checkbox.
XMP 240 C AT • Configuration Tools
on the previous page). If
is selected,
Static IP
radio button and enter
Static
Options dialog box, see the
87