Configuring Ripng To Filter The Received Routes; Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Pre-configuration Tasks
Before configuring the switch to control the receiving of RIPng routing information, complete
the following tasks:
l
l
Data Preparation
To control the receiving of RIPng routing information, you need the following data.
No.
1

3.6.2 Configuring RIPng to Filter the Received Routes

By configure an IPv6 ACL or an IPv6 prefix list to filter received routes, you can configure a
router to selectively receive routes.
Context
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ripng [ process-id ]
The RIPng view is displayed.
Step 3 Run:
filter-policy { acl6-number | acl6-name acl6-name | ipv6-prefix ipv6-prefix-name }
import
The imported routes are filtered.
You can specify an IPv6 ACL or an IPv6 prefix list to filter the imported routes. Only the routes
that pass the filtering can be added to the RIPng routing table.
----End

3.6.3 Checking the Configuration

After the function of controlling the receiving of RIPng routing information is successfully
configured, you can view RIPng routing information.
Issue 01 (2012-03-15)
Configuring IPv6 addresses for interfaces to ensure that neighboring nodes are reachable
at the network layer
Configuring Basic RIPng Functions
Data
ACL used to filter routing information
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RIPng Configuration
71