Entering The Ospfv3 Area View; Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing

5.3.4 Entering the OSPFv3 Area View

By dividing an AS into different areas, specifying OSPFv3 interfaces, and specifying areas to
which these interfaces belong, OSPFv3 can discover and calculate routes in an AS.
Context
You must configure the switches in the same area based on the area. Otherwise, the neighbor
switches cannot exchange information with each other. The congestion of routing information
or routing loop is thus caused.
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospfv3 [ process-id ]
The OSPFv3 view is displayed.
Step 3 Run:
area area-id
The OSPFv3 area view is displayed.
The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4
address format.
An OSPFv3 area cannot be deleted directly. Only after all the configurations in the area view
are removed and the status of the related interfaces in this area become Down, this area is
automatically removed.
----End

5.3.5 Checking the Configuration

After basic OSPFv3 functions are configured, you can check OSPFv3 brief information, LSDB
information, neighbor information, and OSPFv3 routing table.
Prerequisites
The configurations for the Basic OSPFv3 Functions are complete.
Procedure
l
l
l
Issue 01 (2012-03-15)
Run the display ospfv3 [ process-id ] command to check the summary information about
the OSPFv3 process.
Run the display ospfv3 interface [ area area-id ] [ interface-type interface-number ]
command to check the OSPFv3 interface information.
Run the commands as follow to check the LSDB information about OSPFv3:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPFv3 Configuration
190