Checking The Configuration; Configuring A Route Multi-Instance Between An Mce And A Pe; Establishing The Configuration Task - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the bgp as-number command to enable BGP and enter the BGP view.
By default, BGP is disabled.
Step 3 Run the ipv4-family vpn-instance vpn-instance-name command to enter the BGP-VPN
instance view.
Step 4 Run the peer ipv4-address as-number as-number command to configure the device connected
to the MCE in a site as the peer of a VPN private network.
Step 5 (Optional) Run the import-route protocol [ process-id ] [ med med | route-policy route-policy-
name ]
If another routing protocol is run between an MCE and a PE in this VPN, you need to perform
this step.
Step 6 Run the peer ipv4-address allow-as-loop [ number ] command to configure BGP to allow
routing loops.
By default, routing loops are denied.
----End

11.4.7 Checking the Configuration

Run the display ip routing-table vpn-instance command on the MCE. If you can view the route
to the local VPN in the display, it means that the configuration succeeds.
11.5 Configuring a Route Multi-Instance Between an MCE
and a PE
This section describes how to configure static routes, RIP, OSPF, IS-IS, and BGP between an
MCE and a PE.
For configuring a route multi-instance between an MCE and a PE,
Configuring a Static Route Between an MCE and a PE
BGP Between an MCE and a PE

11.5.1 Establishing the Configuration Task

Applicable Environment
To connect a CE to multiple VPNs and isolate services of these VPNs, you need to configure
MCE functions. Before configuring MCE functions, you need to perform the task of
Configuring a VPN Instance
between the MCE and PE.
Issue 01 (2012-03-15)
*
command to import routes from other routing protocols.
NOTE
Generally, BGP detects routing loops through the AS number. Assume that BGP is run between an MCE
and a site. When the MCE advertises the routing information with the AS number to the site, the MCE
cannot receive this routing update from the site because the routing update carries the AS number. In this
case, you need to configure BGP to allow routing loops.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
are optional and can be configured as required.
on the MCE and PE and then configure a route multi-instance
11 MCE Configuration
11.5.2 (Optional)
to 11.5.6 (Optional) Configuring
11.3
636