Huawei S6700 Series Configuration Manual page 233

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 5-1 Networking diagram for configuring an OSPFv3 area
Device name
Switch A
Switch B
Switch B
Switch C
Switch C
Switch D
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Issue 01 (2012-03-15)
SwitchB
VLANIF30
1000::1/64
XGE0/0/2
XGE0/0/1
VLANIF20
1001::1/64
XGE0/0/1
VLANIF20
1001::2/64
SwitchA
XGE0/0/3
VLANIF10
2000::1/64
Area 1
Interface
XGE0/0/1
XGE0/0/1
XGE0/0/2
XGE0/0/2
XGE0/0/1
XGE0/0/2
Configure IPv6 addresses for interfaces.
Enable the basic OSPFv3 functions on each Switch.
Configure Area 2 as a stub area by running the stub command on all the Switches in Area
2 and check the OSPFv3 routing table of Switch D.
Configure the Area 2 as a totally stub area and check the OSPFv3 routing table of Switch
D.
IDs of the VLANs that the interfaces belong to, as shown in
Router ID (1.1.1.1) of Switch A and area (Area 1) where Switch A is located
Router ID (2.2.2.2) of Switch B and areas (Area 0 and Area 1) where Switch B is located
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Area 0
SwitchC
VLANIF30
1000::2/64
XGE0/0/2
5 OSPFv3 Configuration
XGE0/0/1
VLANIF40
1002::1/64
XGE0/0/2
VLANIF40
1002::2/64
SwitchD
Area 2
Stub
VLANIF interface IP address
VLANIF 20 1001::2/64
VLANIF 20 1001::1/64
VLANIF 30 1000::1/64
VLANIF 30 1000::2/64
VLANIF 40 1002::1/64
VLANIF 40 1002::2/64
Figure 5-1
214