Huawei S6700 Series Configuration Manual page 96

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 3-1 Networking diagram for configuring RIPng to filter the received routes
SwitchA
XGE0/0/2
Device name
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Switch C
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Add interfaces to VLANs.
Issue 01 (2012-03-15)
SwitchB
VLANIF20
XGE0/0/1
XGE0/0/1
VLANIF20
VLANIF10
1::1/64
Interface
XGE0/0/2
XGE0/0/1
XGE0/0/1
XGE0/0/2
XGE0/0/1
XGE0/0/2
XGE0/0/3
Enable RIPng on each Switch so that the Switches can communicate with each other.
Configure an ACL on Switch B to filter the received routes.
IDs of the VLANs that the interfaces belong to, as shown in
RIPng1 enabled on each Switch
ACL6 2000 on Switch B, which rejects the routes from network segment 3::/64
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF30
XGE0/0/2
SwitchC
VLANIF40
XGE0/0/1 2::1/64
VLANIF30
XGE0/0/2
VLANIF50
XGE0/0/3
3::1/64
VLANIF interface
VLANIF 10
VLANIF 20
VLANIF 20
VLANIF 30
VLANIF 30
VLANIF 40
VLANIF 50
3 RIPng Configuration
IP address
1::1/64
Generated
automatically
Generated
automatically
Generated
automatically
Generated
automatically
2::1/64
3::1/64
Figure 3-1
77