Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Procedure
l
l
----End

8.12.3 Checking the Configuration

After a BGP4+ confederation is configured, you can check BGP4+ route information and
detailed peer information.
Issue 01 (2012-03-15)
Configuring a BGP4+ Confederation
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
confederation id as-number
The confederation ID is set.
4. Run:
confederation peer-as as-number &<1-32>
The sub-AS number of other EBGP peers connected with the local AS is set.
A confederation includes up to 32 sub-ASs. as-number is valid for the confederation
that it belongs to.
You must run the confederation id and confederation peer-as commands for all the
EBGP peers that belong to a confederation, and specify the same confederation ID for
them.
NOTE
The old speaker with 2-byte AS numbers and the new speaker with 4-byte AS numbers cannot
exist in the same confederation. Otherwise, routing loops may occur because AS4_Path does
not support confederations.
Configuring the Compatibility of a Confederation
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
confederation nonstandard
The compatibility of the confederation is configured.
When the confederation of other switches does not conform to the RFC, you can use
this command to make standard devices be compatible with nonstandard devices.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 BGP4+ Configuration
537