Huawei S6700 Series Configuration Manual page 53

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Context
Do as follows on the RIP switch:
Procedure
l
l
----End
Issue 01 (2012-03-15)
Configuration in a RIP Process (with a High Priority)
1. Run:
system-view
The system view is displayed.
2. Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
3. Run one of the following commands depending on the site requirements.
Run:
silent-interface all
All interfaces are disabled from sending Update packets.
Run:
silent-interface interface-type interface-number
An interface is disabled from sending Update packets.
You can set an interface to silent so that it only receives Update packets to update its
routing table. The silent-interface command takes precedence over the rip output
command in the interface view.
By default, an interface can receive and send Update packets.
Configuration in the Interface View (with a Low Priority)
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
3. Run:
undo rip output
The interface is disabled from sending RIP Update packets.
By running this command, you can specify whether to send RIP Update packets on
an interface. The silent-interface command takes precedence over the undo rip
output command. By default, an interface is allowed to send RIP Update packets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RIP Configuration
34